[cmcfaul@aol.com]

Hello all,

Top end rebuild in the near future. Need to borrow an engine yoke and stand if available. Would probably need it for about a month (hopefully not longer). May also need the head stud puller tool. I think I have everything else (done this before).

Many thanks in advance.

Chris
73 911 E
89 Carrera
703-967-2990
Centreville, VA
cmcfaul@aol.com

[ducatithunder]

I have a p201 and stand you can barrow for a couple months. Its located in MD and will have to come get it.

[jbailey930]

Hi Chris - I have a stud puller. Pm me.

[cmcfaul@aol.com]

Originally Posted by ducatithunder

I have a p201 and stand you can barrow for a couple months. Its located in MD and will have to come get it.

You have no shortage of cool toys.

Where in MD?

Many Thanks,

Chris

[cmcfaul@aol.com]

Originally Posted by jbailey930

Hi Chris - I have a stud puller. Pm me.

Thanks John,

Will Probably take you up on that. Just need to confirm my car has lower Delvar head studs and not steel.

Chris

[ducatithunder]

Originally Posted by cmcfaul@aol.com

You have no shortage of cool toys.

Where in MD?

Many Thanks,

Chris

Thanks. Im in Millersville ... pretty much the Rt32 and I-97 interchange. Just north of Annapolis. Im flying out to work on Tuesday for a month. I can make them available if you are coming up.

[ducatithunder]

You still looking to barrow this rig? Just got back from sea. It’s sitting in my living room.

[cmcfaul@aol.com]

I decided to just do the clutch for now. Car runs perfect and has no noticeable issue except perhaps down on power a bit. It had bad leakdown number on #4 (valve not sealing). So will wait a bit longer on a partial or full rebuild. Leaks and burns essentially zero oil. Clutch (original rubber center) is stiff and tired.

Thanks everyone.

Chris
89 Carrera