Here are some pictures of the new NOS front fenders and nose being fitted to the car after Kent corrected all of the existing damage. Now when you see the seam sealer in the headlight buckets, don't freak out. That is just the way the factory put it on. So that was how Kent did it.
Also in the trunk floor Scotty made and installed the louvered panel to allow the oil cooler to vent hot air out under the car. Scott did a nice job making that panel. All Kent had to do was clean up the welds and then remove the rust.
Last edited by Cairo94507; 06-28-2018 at 08:47 AM.
|