[KeithLambert7]

Originally Posted by SRISER

MIG Welder! Can you weld stainless with that? I would like to cut the left hand exhuast tip of my dansk dual out and re-weld it in a position that matches the right side...so it isn't lopsided.

Christmas was good except:
NO 930S steering wheel
NO "Excellence Was Expected"
NO Tools

What is going on with the wife? I think she might be broken. I even made a very specific list with part numbers and everything. If it doesn't appear for the anniversary on Sunday, have VISA will travel.

Sam,
Sounds like Kurt is your man. I've had my welder for a week, so I wouldn't recommend your setting me loose on your baby...yet! It's been a few years since I've run a bead, and could use a refresher couse. Bummer on the X-Mas gifts issue. My tactic is to list things out for the wife like you did, and use the two kids as foot soldiers to make sure she gets it all. :P

Kurt,
You have a Plasma cutter right? What did you buy, and are you happy with it? Sometime when the garage is open, and your doing MIG/Plasma work, mind if I look over your shoulder?

Keith