Help with 944S wiring
I had postted the question on the profesional forum but started thinking I might be able to get more response here. After being apart for ever, the car is finally back in one piece except for some wires going to the plug by the cam gear. I think this is what the manual calls the Hallgeber. Since my car is an 88 I looked at the 87 wire diagrams in my factory manual. The diagram identifies the three wires as SW (black), GN (green), and RT (red). Only problem is the wire harness on my car is made up of a braided shield, white, and brown wires. The shield is still connected to the pin in the plug, but the white and brown have been pulled from their pins. Where the wires go to the DME I'm not sure if reversing will have an impact. I would greatly appreciate some help fixing this last problem (I hope) so I can get it running this week end. Thanks,
|