Is there an adjustment on the front of the cable?
The adjustment nuts on the tube at the back are run all the way out.
(I can't make the tube any longer) The adjustment bolt on the lever is screwed almost all the way in.
I either going to have to adjust something up front or the cable has streached to the point where there is no adjustment left.
This started when I was trying to take up a little slack. My pedal goes down about 3/4" before it gets stiffer (the point where the big arm starts pushing the little arm on the shaft.) This is where you start feeling the spring pressure from the pressure plate.
I don't see one, but is there a stop that holds the pedal from coming back too far? I know about the one on the floor board, but that stop adjusts how far you can push it down.
Any ideas?
