911 engine Yoke and stand needed
 

Hello all,

Top end rebuild in the near future. Need to borrow an engine yoke and stand if available. Would probably need it for about a month (hopefully not longer). May also need the head stud puller tool. I think I have everything else (done this before).

Many thanks in advance.

Chris
73 911 E
89 Carrera
703-967-2990
Centreville, VA
cmcfaul@aol.com

I have a p201 and stand you can barrow for a couple months. Its located in MD and will have to come get it.

Hi Chris - I have a stud puller. Pm me.

yoke and stand
 

You have no shortage of cool toys.

Where in MD?

Many Thanks,

Chris

stud tool
 

Thanks John,

Will Probably take you up on that. Just need to confirm my car has lower Delvar head studs and not steel.

Chris

Thanks. Im in Millersville ... pretty much the Rt32 and I-97 interchange. Just north of Annapolis. Im flying out to work on Tuesday for a month. I can make them available if you are coming up.

You still looking to barrow this rig? Just got back from sea. It’s sitting in my living room.

I decided to just do the clutch for now. Car runs perfect and has no noticeable issue except perhaps down on power a bit. It had bad leakdown number on #4 (valve not sealing). So will wait a bit longer on a partial or full rebuild. Leaks and burns essentially zero oil. Clutch (original rubber center) is stiff and tired.

Thanks everyone.

Chris
89 Carrera