Powder Coating Setup

[frogers911]

I recently remodeled my kitchen, so what better to do with the old electric oven then set it up in the garage to do some powder coating.

I went the cheap route with harbor freight stuff, I have only done a couple of parts so far but it seems to work ok. I also picked up a bench top bead blaster cabinet.

If anyone wants to test it out I have a few colors you can try. Blast cabinet working area is ~25"x15"x15" . Oven is your standard size.

[little b]

wow. i would have never thought to do that with the old oven.....too cool.
oh wait! why not do it just in the kitchen!
Step one: put parts in sink to get surface gunk off.
Step two: place parts in dishwasher.
Step three: powder parts on clean counter top
Step four: cook parts till golden brown or when legs fall off bushings.

[lpsalsaman]

wow. i would have never thought to do that with the old oven.....too cool.
oh wait! why not do it just in the kitchen!
Step one: put parts in sink to get surface gunk off.
Step two: place parts in dishwasher.
Step three: powder parts on clean counter top
Step four: cook parts till golden brown or when legs fall off bushings.

You forgot step five: Wife kicking your "A" all over the place for that! :mrgreen:

[dweymer]

ballsy...

see here
http://www.gruppeb.org/forum/viewtopic.php?t=3176&highlight=

I am just finishing building my oven, 28x36x45...hope it works!