Navigation » Dorkiphus.net
»
How do you remove the chain ramps
| Porsche Technical Discussions Porsche related technical discussions and questions go here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
09-04-2010, 03:39 PM
|
|||
|
|||
How do you remove the chain ramps
I am stuck. The book says to use a little screw driver and wedge the Circle clip out of it's groove. Is there a trick to this? I don't seem to be able to wedge anything in there.
The back of one the ramps has a split. Do I pry that appart and pull it off. It's the little things. Thanks Chris 79 911 E - rebuild mode
__________________
Chris M 73 911 E 89 Carrera 
|
|
#2
09-05-2010, 11:23 AM
|
||||
|
||||
IIRC, just pull/pry like a muther. x10 if you're replacing them
 I don't remember a circlip, just an indent on each pin that the plastic ramp has a roundish tab that kind of drops into. It was much harder to get the old rock hard ones off than the new ones on (or even off, since I put one on backwards and had to pop it off to flip over.)
__________________
Stephen www.salazar-racing.com 1970 914/6 - 3.0L GT 1983 911SC - 3.32L IROC 1984 930 - 3.6L dirt bikes (some gas, some electric), Sherco trials bike Sold: 2001 Boxster (hers), 2003 996tt x50  , SpecE30, 1996 E36M3 GTS2 racecar, 2015 Mustang GT, 2008 S2R1000
|
|
#3
09-05-2010, 06:02 PM
|
||||
|
||||
|
Look under each ramp and you'll see to small plastic tabs. The tabs lock into the indent on the ramp "pins". Wedge a little screwdriver under each tab and lift up (releasing the tabs from their indent), at the same time wedge/pry with a larger screwdriver between ramp/case to slide ramp off.
__________________
Kyriakos E. Stylianos Baglama inspired 1982 SC Targa - (Currently Wallowing for GothingNC)
|
|
#4
09-05-2010, 08:56 PM
|
|||
|
|||
|
Came right off once I got a 90 degree screw driver behind them and just pried them off.
Heads come off tomorrow. Chris 73 911 e AKA Humpty
__________________
Chris M 73 911 E 89 Carrera
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
